Difference between revisions of "Hardware Profile"
m (revert spammed page) |
(→Hardware Overview) |
||
Line 36: | Line 36: | ||
|} | |} | ||
Apple TV runs an Extensible Firmware Interface (EFI) | Apple TV runs an Extensible Firmware Interface (EFI) | ||
+ | |||
+ | |||
+ | '''Source(s):''' [http://www.downloadranking.com/product_detail.php/pid/16018-10 Hardware Profile] | ||
+ | |||
===Photos of AppleTV internals:=== | ===Photos of AppleTV internals:=== |
Revision as of 17:55, 26 December 2012
The Apple TV includes the system_profile command line tool. These tables were generated using the information provided by Awkward on The Something Awful Forums.
Contents
Hardware Overview
Machine Name: | Mac |
Machine Model: | AppleTV1,1 |
Processor Speed: | 1 GHz |
Number of Processors: | 1 |
Total Number of Cores: | 1 |
Memory: | 256 MB |
Bus Speed: | 400 MHz |
Boot ROM Version: | ATV11.00D9.B00 |
Serial Number: | Machine Specific |
L2 Cache: | 2 MB |
Apple TV runs an Extensible Firmware Interface (EFI)
Source(s): Hardware Profile
Photos of AppleTV internals:
http://www.engadget.com/photos/apple-tv-dissected/
Network
The system has both a wired ethernet port and an 802.11b/g/n AirPort card. Some of this information will vary depending on if the device is attached and its specific configuration. This information is in italics where identified.
Ethernet
This table shows typical settings when the device is connected via a wired ethernet connection.
Type: | Ethernet | ||||||||||||||
Hardware: | Ethernet | ||||||||||||||
BSD Device Name: | en0 | ||||||||||||||
Has IP Assigned: | Yes | ||||||||||||||
IPv4 Addresses: | x.x.x.x | ||||||||||||||
IPv4: |
| ||||||||||||||
IPv6: |
| ||||||||||||||
DNS: |
| ||||||||||||||
DHCP Server Responses: |
| ||||||||||||||
Proxies: |
| ||||||||||||||
Ethernet: |
|
AirPort
This table shows the typical settings when the AirPort device is not in use.
Type: | AirPort | ||||||
Hardware: | AirPort | ||||||
BSD Device Name: | en1 | ||||||
Has IP Assigned: | No | ||||||
IPv4: |
| ||||||
Ethernet: |
|
System Software
This table shows information regarding the original shipping version of the system software.
System Version: | Apple TV OS 10.4.7 (8N5107) |
Kernel Version: | Darwin 8.8.2 |
Boot Volume: | OSBoot |
Computer Name: | AppleTV |
User Name: | System Administrator (root) |
ATA
TODO
Audio
The audio on the Apple TV is provided by Intel High Definition Audio and provides only audio output features.
Line Out: |
| ||
S/P-DIF Out: |
|
Diagnostics
This shows the results of the Power On Self Test.
Last Run: | Last Machine Reboot |
Result: | Passed |
FireWire
The Apple TV does not include a FireWire port.
Graphics & Displays
Graphics
Chipset Model: | GeForce Go 7300 |
Type: | Display |
Bus: | PCIe |
VRAM (Total): | 64 MB |
Vendor: | NVIDIA (0x10de) |
Device ID: | 0x01d7 |
Revision ID: | 0x00a1 |
ROM Revision: | 3144 |
Displays
Resolution: | 1280 x 720 @ 60 Hz |
Depth: | 32-bit Color |
Core Image: | Supported |
Main Display: | Yes |
Mirror: | Off |
Online: | Yes |
Quartz Extreme: | Not Supported |
Rotation: | Supported |
Memory
The Apple TV has two logical memory banks, 0 and 1, but only one of these is occupied.
The system has a total memory compliment of 256 MB of DDR2 SDRAM.
Bank 0
Size: | 256 MB |
Type: | DDR2 SDRAM |
Speed: | 400 MHz |
Status: | OK |
Bank 1
Size: | Empty |
Type: | Empty |
Speed: | Empty |
Status: | Empty |
Power
The device is designed to operate solely on AC power and has no built in facility to use batteries or other DC power sources.
System Sleep Timer (Minutes): | 0 |
Disk Sleep Timer (Minutes): | 0 |
Display Sleep Timer (Minutes): | 0 |
Sleep On Power Button: | No |
Automatic Restart On Power Loss: | Yes |
USB
USB High-Speed Bus: |
| ||||||||||||||||||||||||||
USB Bus: |
|
AirPort Card
The Wireless Card Locale may be different depend on the country where the device was purchased.
Wireless Card Type: | AirPort Extreme (0x14E4, 0x87) |
Wireless Card Locale: | USA |
Wireless Card Firmware Version: | Broadcom BCM43xx 1.0 (4.80.79.1) |
Current Wireless Network: | AirPort is currently turned off |
Locations
TODO
system_profiler Output
bash-2.05b# system_profiler
Hardware: Hardware Overview: Machine Name: Mac Machine Model: AppleTV1,1 Processor Speed: 1 GHz Number Of Processors: 1 Total Number Of Cores: 1 Memory: 256 MB Bus Speed: 400 MHz Boot ROM Version: ATV11.00D9.B00 Serial Number: L2 Cache: 2 MB Network: Built-in Ethernet: Type: Ethernet Hardware: Ethernet BSD Device Name: en0 Has IP Assigned: Yes IPv4 Addresses: [Removed -- Awkward] IPv4: Addresses: [Removed -- Awkward] Configuration Method: DHCP Interface Name: en0 Router: [Removed -- Awkward] Subnet Masks: [Removed -- Awkward] IPv6: Configuration Method: Automatic DNS: Domain Name: blah blah blah Server Addresses: [Removed -- Awkward], [Removed -- Awkward] DHCP Server Responses: Domain Name: [Removed -- Awkward] Domain Name Servers: [Removed -- Awkward] Lease Duration (seconds): 0 DHCP Message Type: 0x05 Routers: [Removed -- Awkward] Server Identifier: [Removed -- Awkward] Subnet Mask: [Removed -- Awkward] Proxies: FTP Proxy Enabled: No FTP Passive Mode: Yes Gopher Proxy Enabled: No HTTP Proxy Enabled: No HTTPS Proxy Enabled: No RTSP Proxy Enabled: No SOCKS Proxy Enabled: No Ethernet: MAC Address: [Removed -- Awkward] Media Options: Full Duplex Media Subtype: 100baseTX Type: AirPort Hardware: AirPort BSD Device Name: en1 Has IP Assigned: No IPv4: Configuration Method: DHCP Ethernet: MAC Address: [Removed -- Awkward] Media Options: Media Subtype: autoselect Software: System Software Overview: System Version: Apple TV OS 10.4.7 (8N5107) Kernel Version: Darwin 8.8.2 Boot Volume: OSBoot Computer Name: AppleTV User Name: System Administrator (root) ATA: ATA Bus: FUJITSU MHW2040AT: Capacity: 37.26 GB Model: FUJITSU MHW2040AT Revision: 0081000C Serial Number: [Removed -- Awkward] Removable Media: No Detachable Drive: No BSD Name: disk0 Protocol: ATA Unit Number: 0 Socket Type: Internal Low Power Polling: No OS9 Drivers: No S.M.A.R.T. status: Verified Volumes: OSBoot: Capacity: 900 MB Available: 422.18 MB Writable: Yes File System: Journaled HFS+ BSD Name: disk0s3 Mount Point: / Media: Capacity: 35.96 GB Available: 35.19 GB Writable: Yes File System: Journaled HFS+ BSD Name: disk0s4 Mount Point: /mnt Volumes: disk0s3: Capacity: 900 MB Available: 422.18 MB Writable: Yes File System: Journaled HFS+ disk0s4: Capacity: 35.96 GB Available: 35.19 GB Writable: Yes File System: Journaled HFS+ Audio (Built In): Intel High Definition Audio: Available Devices: Line Out: Connection: RCA S/P-DIF Out: Connection: Optical Diagnostics: Power On Self-Test: Last Run: [Removed -- Awkward] Result: Passed FireWire: Graphics/Displays: GeForce Go 7300: Chipset Model: GeForce Go 7300 Type: Display Bus: PCIe VRAM (Total): 64 MB Vendor: NVIDIA (0x10de) Device ID: 0x01d7 Revision ID: 0x00a1 ROM Revision: 3144 Displays: Resolution: 1280 x 720 @ 60 Hz Depth: 32-bit Color Core Image: Supported Main Display: Yes Mirror: Off Online: Yes Quartz Extreme: Not Supported Rotation: Supported Memory: BANK 0/DIMM0: Size: 256 MB Type: DDR2 SDRAM Speed: 400 MHz Status: OK BANK 1/DIMM1: Size: Empty Type: Empty Speed: Empty Status: Empty Power: System Power Settings: AC Power: System Sleep Timer (Minutes): 0 Disk Sleep Timer (Minutes): 0 Display Sleep Timer (Minutes): 0 Sleep On Power Button: No Automatic Restart On Power Loss: Yes USB: USB High-Speed Bus: Host Controller Location: Built In USB Host Controller Driver: AppleUSBEHCI PCI Device ID: 0x27cc PCI Revision ID: 0x0002 PCI Vendor ID: 0x8086 Bus Number: 0xfd USB Bus: Host Controller Location: Built In USB Host Controller Driver: AppleUSBUHCI PCI Device ID: 0x27c8 PCI Revision ID: 0x0002 PCI Vendor ID: 0x8086 Bus Number: 0x1d IR Receiver: Version: 2.42 Bus Power (mA): 500 Speed: Up to 1.5 Mb/sec Manufacturer: Apple Computer, Inc. Product ID: 0x8241 Vendor ID: 0x05ac (Apple Computer, Inc.) AirPort Card: AirPort Card Information: Wireless Card Type: AirPort Extreme (0x14E4, 0x87) Wireless Card Locale: USA Wireless Card Firmware Version: Broadcom BCM43xx 1.0 (4.80.79.1) Current Wireless Network: AirPort is currently turned off Locations: Automatic: Active Location: Yes Services: Built-in Ethernet: Type: Ethernet BSD Device Name: en0 Hardware (MAC) Address: [Removed -- Awkward] IPv4: Configuration Method: DHCP IPv6: Configuration Method: Automatic AppleTalk: Configuration Method: Node Proxies: FTP Proxy Enabled: 0 FTP Passive Mode: 1 Gopher Proxy Enabled: 0 HTTP Proxy Enabled: 0 HTTPS Proxy Enabled: 0 RTSP Proxy Enabled: 0 SOCKS Proxy Enabled: 0 Type: IEEE80211 BSD Device Name: en1 Hardware (MAC) Address: [Removed -- Awkward] IPv4: Configuration Method: DHCP IEEE80211: AllowNetCreation: 1 JoinMode: Automatic MAC Address: [Removed -- Awkward]
Thanks Awkward. Cited from http://forums.somethingawful.com/showthread.php?threadid=2391956&perpage=40&pagenumber=4